MHSC CRLDVPS Instrucciones de operaciones descargar pdf (Pagina 4)

20306750

Designer Series Direct Vent Gas Fireplace

IMPORTANT SAFETY INFORMATION

12. Do not use this replace to cook food or burn paper or

other objects.

13. Never place anything on top of replace.

14. Do not use any solid fuels (wood, coal, paper, card-

board, etc.) in this replace. Use only the gas type

indicated on rating plate.

15. This appliance, when installed, must be electrically

grounded in accordance with local codes or in the

absence of local codes, with the National Electrical

Code, ANSI/NFPA 70, or the Canadian Electrical Code,

CSA C22.1.

16. Do not obstruct the ow of combustion and ventilation

air in any way. Provide adequate clearances around

air openings into the combustion chamber along with

adequate accessibility clearance for servicing and

proper operation.

17. When the appliance is installed directly on carpeting,

tile or other combustible material other than wood oor-

ing, you must set appliance on a metal or wood panel

or hearth pad extending the full width and depth of the

appliance.

18. Do not use replace if any part has been exposed to

or has been under water. Immediately call a qualied

service technician to inspect the appliance and replace

any part of the control system and any gas control which

as been submerged in water.

19. Do not operate replace if any log is broken.

20. Do not use a blower insert, heat exchanger insert, or

any other accessory not approved for use with this

replace.

21. Do not operate the replace with glass door removed,

cracked, or broken.

CODE APPROVAL

Direct Vent type appliances draw all combustion air from

outside of the dwelling through the vent pipe.

These appliances have been tested by CSA and found to

comply with the established standards for DIRECT VENT

GAS FIREPLACE HEATERS in the USA and Canada as

follows:

LISTED VENTED GAS FIREPLACE HEATER

TESTED TO:

ANSI Z21.88-2014 / CSA 2.33-2014 STANDARDS

A manufactured home (USA only) or mobile home OEM

installation must conform with the Manufactured Home

Construction and Safety Standard, Title 24 CFR, Part

3280, or when such a standard is not applicable, the

Standard for Manufactured Home Installations, ANSI/

NCSBCS A225.1, or Standard for Gas Equipped Recre-

ational Vehicles and Mobile Housing, CSA Z240.4.

WARNING

Never connect unit to private (non-utility)

gas wells. This gas is commonly known

as wellhead gas.

IMPORTANT:

PLEASE READ THE FOLLOWING CAREFULLY

It is normal for replaces fabricated of steel to

give off some expansion and/or contraction noises

during the start up or cool down cycle. Similar

noises are found with your furnace heat exchanger

or car engine.

IMPORTANT:

PLEASE READ THE FOLLOWING CAREFULLY

It is not unusual for gas replace to give off some

odor the rst time it is burned. This is due to the

manufacturing process.

Please ensure that your room is well ventilated

during burn off — open all windows.

It is recommended that you burn your replace for

at least ten (10) hours the rst time you use it. Place

the fan switch in the “OFF” position during this time.

DANGER

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

Un panneau vitré chaud peut

causer des brûlures.

Laissez refroidir le panneau

vitré avant d’y toucher.

Ne laisser jamais les enfants

toucher le panneau vitré.

A barrier designed to reduce the risk of burns from

the hot viewing glass is provided with this

appliance and shall be installed.

Une barrière visant à réduire le risque de brûlure

par le hublot chaude est fournie avec cet

appareil et doit être installé.

DANGER

1 2 3 4 5 6 7 8 9 ... 63 64

Comentarios a estos manuales

Sin comentarios

MHSC CRLDVPS Instrucciones de operaciones Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Chimeneas MHSC CRLDVPS